bluNFC Instructions

Essentials

Data

In this section you'll learn how to access your logger's data.

General data

In order to access general data from your loggers (that is what you see on the table), first select “Logger” and then “Read Logger” from the top menu.
You should be able to see the window with a map (if you have a “Check the location before reading data” option enabled in the settings).
Please make sure the location is correct. Use the zoom functionalities on the top left to zoom in and out the map. In order to change the location, click on the map and the pointer will change its location. Once you are satisfied, click the “Save” button.
A window will open inviting you to place the first logger on the reader. Follow the instructions and wait a few seconds. You can read as many loggers in a row as you wish. After a successful reading you should be able to see the message “Success – Change logger”.

Once you are finished, just close the window. You should see row(s) with logger(s) data.

If you have indicated your bluConsole login, data will be automatically uploaded to your account and will be available on www.bluconsole.com.

If you see the message “Error – Change logger”, there could be few possible causes:

Removing the logger from the NFC reader too quickly (during the “Data transmission in progress” step)
NFC reader issue or other issue – just remove the logger and put it again on the reader. Repeat it few times till it works.

Make sure to close your window after you are finished. When the window is opened you will not be able to access the top menu of the app.

If you can not find the window, please click the bluNFC menu located at the bottom of your screen. Just click on the “X” icon at the top right.

Recording parameters & map

In order to access recording data for a specific logger, click the “gear” icon on the right.
Click the “Yes” button if you would like to use data from the row (that means it will use data that was already saved in the app). If you would like to use data directly from the logger, click the “No” button.
Place the logger on the NFC reader and click the icon again.
A new window will pop up showing you the recording data.

In order to see the last recorded position on the map, click the “pin” icon located at the bottom. The map will zoom in to this position.

History

In order to access the history of the recordings, click the “timer” icon. A new window should pop up showing the list of recordings with various data.
In order to delete a recording, click the “trashbin” icon located at the right.
In order to access recording parameters of a recording, click the “gear” icon.
In order to access a graph of a recording, click the “graph” icon.

In order to edit the name of the recording, click the “pen” icon located at the right. A new window should pop up.
On this new window type a new name and click the “Save” button.

Last recording data

In order to access last recording data, first place the logger on the NFC reader.
Then select from the top menu “Logger” and “Last recording data” option. A new window should pop up showing you the last recording data.

Last recording data will show you data from the most recent recording.

Last block of measurements

In order to access the last block of measurements, first place the logger on the NFC reader.
Then select from the top menu “Logger” and “Read the last block of measurements” option.
A window will open inviting you to place the logger on the reader. Follow the instructions and wait a few seconds.
Once you have finished, just close the window.

In comparison to the “Read logger” option, “Read the last block of measurements” allows you to read just a few of the most recent recordings, making the loading of data much faster.