English 
Français 
Español 
Polski Before placing loggers at your desired positions I would like to show you some useful installation tips to make sure everything works out perfectly fine for you. Please follow them while placing your devices.
Installation Tips
Tip 01 — No water, please
Avoid direct contact with water (except for the waterproof probe).
Tip 02 — No metal, please
Do not install it on a or near metal surface. If it is required, please separate it, for instance by a plastic plate.
Tip 03 — Keep me close!
Please make sure to place your loggers within the 700 meter range from the hub to ensure the connection between devices.
Installation
Once you follow these tips, you can now install the loggers in the desired locations.
You can install them using an adhesive tape or a clamp band.
Adhesive tape
Clamp band
Final check
Thank you for following the tips. Now, go back to bluConsole and make sure that all of your installed hubs and loggers are connected.
In case some hubs are not connected, first check if there is any issue with the power source.
In case the loggers do not appear to connect, move them closer to the hub.
If these problems persist, don’t worry! Please continue reading this instructions manual to the next section, Troubleshooting.
